CYLINDER BORING / MACHINING / GRINDING 
Between Randy and our on-site machinist, there is over 50 years of experience in 
automotive & motorcycle machining.  Our shop has several lathes, a drill press, and several 
grinding tools.  We bore cylinders at 1 hour labor per cylinder when combined with
engine rebuilding.  (We don't perform machine work separate from engine rebuilding.) Our labor rate is $90/hr.
Machining a 38mm handlebar clamp to fit a 39mm fork tube
Creating a wheel spacer for a
 1974 Norton Commando 850 custom
BEFORE of a stock Honda CB750 cylinder head
AFTER of the cylinders bored to 836 cc + the Wiseco piston kit
Installing & inspecting File to fit piston rings on a 1974 Yamaha TX650 / 750
Machining a tappet block to accept early push rod tubes
Website created and managed by Ursulina Creel.  Comments? Send to info@rcycle.com
This page was last updated on: February 14, 2018
Website & video content is the property of Randy's Cycle Service & Restoration & may not be used for any reason without prior, written permission.
Revitalize the Spirit & Beauty of your Classic Bike
Services We Offer
Restoration of Vintage Motorcycles
Help on Vintage Motorcycles
Upcoming Vintage Motorcycle Events
Randy's Blog about his Honda CB750
Directions / Map
Contact Us / Hours
About Us
Located in beautiful Central Virginia since 2001
8175 Black Walnut Run Road, Rhoadesville, VA 22542 USA

Service by Appointment ~ Closed Sun, Mon & Thur

The Mid-Atlantic Region Premier Restorer of 
Vintage Motorcycles from the 50s, 60s & 70s
HOME page of rcycle.com
   rcycle.com       info@rcycle.com